Pa'yakshuvach leelit on 12.16 TA 20 liters

Water softener & nbsp; Lelit is used to prepare water for steam generators of consolers to soften water, in the water supply network, followed by its use for pouring into steam generators. Functions at the working pressure of the water supply network itself from 0.5 to 2.5 bar. Only tap water at room temperature is used above 0 degrees. It operates only on a resin of suitable for food needs, in order to form an ion exchange. Regeneration occurs using kitchen salt (NACL), no other chemical or natural composition. The regeneration process requires a certain period of time, and also depends on the stiffness of the water itself 20 ° F, 30 ° F, 40 ° F. The connection should be made by qualified specialists. Staff and inclusion: 1. Install the water supply on a stable surface, next to the entrance of the drinking water supply pipeline. The height of the installation should provide the possibility of installing the required container for collecting softened water (we recommend using plastic canists of 20 liters). 2. Connect the water from the drinking water supply to the upper cranes of the water supply. You can connect a flexible hose that withstand the working pressure of your water supply or by hard connection with the pipeline (the hose is not included). 3. Install the fitting of a flexible hose at the threaded end of the lower edge (it does not enter), put on a flexible hose and fix it with an appropriate clamp, lower the end of the hose in & nbsp; a container for collecting softened water. 4. Fasten the tube at another output of the lower crane (included in the kit) and lower its end into the container for collecting water after regeneration or in the sewer. 5. The water supply is ready to work. 6. You can store softened water, tightly closing the lids. 7. When using contaminated water - claims to the work of a water supply are not accepted. & nbsp; The regeneration process: 1. Switch the taps to position No. 2, completely drain the water remaining after regeneration 2. Open the cover of the water supply (from above) and fill the kitchen salt (NACI), the amount of salt is indicated in table No. 1. The use of other products is not allowed. 3. Remove the remaining salt or resin from the contact parts of the cover of the lid and set the lid back. 4. Switch the taps to position No. Z. Attention: Switch the lower tap first, and then the upper. 5. The time of the regeneration process depends on the degree of use of resin and stiffness of the source water. Drain salted water until it becomes soft. When using the water supply, drain the water from the lower tap into the sewer until it is transparent. If the water supply was not used for more than 48 hours, then also drain the water into the sewer until it becomes clean. The service life of a special resin in the device is 5-7 years, depending on the rigidity of the source water. The supplied water into the device should not contain mechanical impurities and rust. When using contaminated water, claims to the operation of the device are not accepted.